The heat transfer process in the heat exchanger is not only a heat transfer phenomenon, but the important thing is the fluid flow state. The heat exchanger has a controlling effect on the heat transfer excess. The heat transfer boundary layers on both sides of the heat transfer surface constitute the main thermal resistance of the heat exchanger. When the degree of fluid turbulence increases, this boundary layer becomes thinner, and the smaller thermal resistance is helpful for heat transfer. On the contrary, when the degree of turbulence decreases, it is detrimental to heat transfer.
In addition, the thickness of the heat exchanger wall should also be limited. The value of heat recovery from the feeder, the heat transfer area of the heat exchanger and the heat exchange price are inversely proportional to the fluid friction resistance, thus also affecting the cost of power. Generally, reasonable site economical design and operation data are obtained after the type is decided, but it is inconvenient to not know the general range of economic conditions before selecting the type.
Therefore, the heat exchanger design should roughly give the heat transfer coefficient and type. Find the rough heat transfer area, and at the same time, the heat exchanger needs to study the appropriate temperature difference. The flow denier ratio of the two fluids is the governing condition for this degree difference.
Please indicate the source when reprinting:
http://www.wxmwhg.com/