Design Considerations for Hot and Cold Fluid Flow Channel Selection in Heat Exchanger
Inside
the heat exchanger, hot and cold fluid flow channels can be selected according to the following principles:
1. Liquids that are unclean and easy to scale should go through the pipeline, because it is convenient to clean inside the pipeline;
2. Corrosive fluids should take the pipe stroke to avoid corrosion of the tube bundle and the shell at the same time;
3. The pipe stroke with high pressure should be avoided to avoid the pressure on the heat exchanger shell;
4. The saturated steam should go through the shell, because the saturated steam is relatively clean, the convective heat transfer coefficient is independent of the flow rate, and the condensate is easy to discharge;
5. The cooled fluid should travel through the shell to facilitate heat dissipation;
6. If the temperature difference between the two fluids is large, for a heat exchanger with a rigid structure, it is advisable to pass the fluid with a large convective heat transfer coefficient through the shell, which can reduce thermal stress;
7. The flow rate of the fluid is small and the viscosity is large.
Reproduced Please indicate the source:
http://www.wxmwhg.com