Shell Side Setting Characteristics of Tube Condenser
When the tubular condenser exchanges heat, the cooling water enters through the connecting tube of the top cover and flows in the tube. This path is called the pipe path; the harmful vapor flows in the gap between the tube bundle and the shell, this path is called the shell path; the outer surface area of the tube bundle is the heat transfer area.Condensation recovery In the condensation process, whether for saturated vapor or non-condensing gas, condensation generally occurs in the shell of the equipment, because it is reasonable in terms of heat transfer, pressure drop and cleaning, as follows:
1. The heat transfer coefficient of the horizontal shell condensing film is high, and at the same time, the non-condensate will not accumulate at the dead angle and is not easy to discharge.
2. It is easy to clean the scale in the cooling water pipe.The contents of the water escape pipe tend to have a high flow rate, which is helpful for reducing the speed of scale formation and increasing the heat transfer coefficient of the water film.
3. The
tubular condenser makes the lower tube at the cooling water inlet, and the condensate accumulates in the bottom layer to reduce the temperature of the condensate.In the external condensing system, it is important for the condensate to be further cooled. If the temperature in the condensing system is high, a large amount of volatilization will occur in the contact air. The general condensate inlet temperature is required to be 60 ℃.Of course, a separate cooler can be added, but this will increase the cost.