Why is it said that the electric heating reactor has good sealing effect?
The
electric heating reaction kettle has a good sealing effect. When tightening the main nut, the specified tightening torque must not be exceeded within the range of 40-120N.M. Do not let the sealing surface be squeezed or overloaded. The sealing surface should be taken care of. Before each installation, wipe the upper and lower sealing surfaces with a relatively soft paper or cloth. Pay attention not to scratch the sealing surfaces of the kettle body and the kettle cover. If reasonable operation can be used more than 10,000 times, the sealing surface must be repaired to achieve good sealing performance. When removing the kettle cover, the kettle cover should be slowly lifted up and down, and the sealing surface between the kettle body and the kettle cover should not collide with each other.If the sealing type is gasket sealing (tetrafluoro, aluminum pad, copper pad, asbestos pad, etc.), a good sealing effect can be achieved by tightening the main nut.
1. When the electric heating reaction kettle is cooled, the water can be cooled internally through the cooling coil, and rapid cooling is prohibited, and there is no excessive temperature difference pressure, resulting in cracks in the cooling coil and the kettle body.Before starting up, it is necessary to pass cooling water through the water jacket between the magnetic stirrer and the lid of the kettle to ensure that the water temperature is 35 °C, so as to avoid demagnetization of magnetic materials.Installation device: The arched metal bursting disc is made of stainless steel and manufactured according to the standard. It has been debugged at the factory and must not be adjusted at will.If the bursting needs to be replaced, the replacement period shall be determined by the user according to the actual situation of the unit. For overbursting discs that are not replaced by bursting pressure, it is often used or 80% of the lower limit pressure of the bursting disc. When replacing, pay attention to the convex surface of the bursting disc.
2. After the reaction of the electric heating reaction kettle is completed, prioritize cooling and cooling, and then discharge the gas in the kettle to the outside through the pipeline to reduce the pressure in the kettle to normal pressure. It is strictly forbidden to disassemble with pressure, then loosen and remove the main bolts and nuts symmetrically, and then carefully remove the kettle cover (or raise the kettle cover) on the bracket. During the unloading process, pay attention to protecting the sealing surface of the kettle body and the kettle cover.Cleaning in the kettle: Clean the residue of the kettle body and sealing surface with the cleaning solution after each operation (use the cleaning solution to avoid corrosion to the main body material). It should be cleaned frequently and kept clean. It is not allowed to be cleaned with hard substances or rough surfaces.
Reproduced Please indicate the source: http://www.wxmwhg.com/detail133.html