Welding Characteristics of Tube Condenser
16px;">In order to ensure the smooth progress of the welding process and ensure the welding quality to meet the technical requirements, special attention should be paid to the following points during welding design:
The design should provide space for these tools, especially near large flange connections, which is often the case on shell and tube condensers. A 75-100 mm gap should be left around the nozzle to facilitate welding, which is also an important consideration when selecting the length of the equipment shell.
Therefore, in the welding design, measures must be taken to prevent these gases from entering the weld and ensure that the inert gases can reach the back side for protection. If the joint cannot be reached, repair and inspection will become more difficult. To ensure inert gas rest, a dew point indicator or a large enough gas volume can be used instead.
3. Due to the low thermal conductivity of stainless steel, a higher metal temperature will be generated during the welding process, which is similar to stainless steel welding. Above 315V, the loss of strength makes tack welds, deposited weld metal and butt edges more susceptible to softening and cracking than other types of steel. In order to ensure the alignment of miswelded joints, segmented positioning welding must be used, back protection measures are in place, and external restrictions are strict. The design should use symmetrical (double-sided) welds wherever possible, avoid T-joints with full penetration grooves and fillet welds on the same side of the joint.