Welcome to [Wuxi Chemical Equipment Co., Ltd.] website!

咨询热线:

Selection of Welding Process for Tube Condenser

The correct selection of welding technology for tube condensers is an important factor in ensuring quality. In addition to considering the selection of welding method, welding rod, welding position, transportation conditions, etc., there are also pre-weld preheating and post-weld heat treatment to consider. Whether preheating is required and its temperature and method should be determined according to the performance of the metal material and the preheating conditions. In order to reduce welding deformation and residual stress, both ends of each pipe are spot welded to the tube plate in sequence. Each pipe needs to be spot welded at evenly distributed points before welding. The number of divided areas depends on the diameter of the tube sheet. Large tube sheets can be divided into several more areas.
In order to ensure the welding quality of tube condenser, the end surface of the tube mouth, the outer surface of the tube end and the wall surface of the tube plate hole must be purified. First clean the gray carbon, oil, rust and other impurities, then use acetone or carbon tetrachloride to degrease the welded part, and blow it clean with compressed air. The range is the outer circle of the pipe end, and its length should be slightly larger than the thickness of the tube plate.
1016 次

相关文档

Copy right © 2019 Wuxi Chemical Equipment Co., Ltd. All Rights Reserved Website Design: Wuxi Wangke