External Devices and Circulating Water Usage of Condenser
The condenser usually installs a series of baffles perpendicular to the tube bundle outside the tubes. At the same time, the connection between the tubes, the tube sheet and the shell are rigid. There are two types of fluids with different temperatures inside and outside the tube. When the temperature difference between the tube wall and the shell wall is large, considering the difference in thermal expansion between the two, a large temperature difference stress is formed, causing the tubes to twist or loosen from the tube plate, which is likely to damage the equipment.
However, the compensation device (expansion joint) can only be used when the temperature difference between the shell wall and the pipe wall is lower than 60 to 70°C and the shell side fluid pressure is not high. Under normal circumstances, when the shell side pressure is higher than 0.6Mpa, the compensation ring is too thick, does not easily expand and contract, and loses the function of temperature difference compensation, so other structures should be considered.
On the one hand, it is the use of circulating water, such as secondary circulating water. Soft water after softening should be selected as the secondary circulating water of the condenser. This can also control the impurity content in the water to not exceed the standard and ensure its purity. On the other hand, if the equipment is used in a central heating system, you can also choose the method of replenishing water for the secondary time. Another important point is to regularly clean the dirt in the flow channel or the scale on the plate.
But it is much easier to disassemble and clean. Soak the plate in the cleaning solution for 30 minutes, then use a soft brush to lightly brush the scale, and then clean it with clean water. Avoid damaging the plate and rubber pad during the cleaning process.