Working principle of distillation tower
In fermented mature mash, it not only contains alcohol, but also contains dozens of other ingredients. If water is added, the content of these substances far exceeds the alcohol content. The alcohol content in mature mash is only about 7-11% (capacity), and impurities including water, alcohols, aldehydes, acids, and lipids account for almost 90%. To obtain pure alcohol, certain methods must be used to separate alcohol from mature mash.
In production, heated distillation is used to separate various substances with different boiling points, specific gravity, and volatility from different equipment to obtain high-purity alcohol.
The working principle of the crude distillation tower is that after the fermented mature mash is preheated, it enters the upper part of the crude distillation tower. The bottom of the tower is continuously and evenly supplied with heated steam. At this time, due to the effect of heating, the liquid alcohol in the mature mash can be converted into alcohol gas. At the same time, other low boiling point and volatile impurities become gaseous and enter the aldehyde discharge tower (or directly into the rectification tower) together with the alcohol. The bottom of the tower discharges the distilled waste residue out of the tower.
When the crude distillation tower is operating normally, the tower top temperature must not be lower than 93°C, but it cannot be too high. Too high a top temperature is not beneficial to separation and consumes a lot of steam. Generally controlled at 95-96℃.
The temperature is too low and the alcohol in the wake does not completely evaporate, so the alcohol evasion rate increases significantly.
Mature mash must be preheated before entering the crude distillation tower to reduce the temperature difference, which is beneficial to the stable operation of the crude distillation tower.
Generally, the mash preheating temperature should be controlled between 60-70℃. In some production units, due to the influence of equipment performance, the temperature is generally lower than 5-10℃.
The working principle of the aldehyde removal tower is that after crude distillation, the alcohol in the mature mash enters the aldehyde removal tower from the top of the crude distillation tower. After appropriate heating, condensation and reflux in the aldehyde removal tower, the crude alcohol is Low boiling point, volatile impurities such as aldehydes and esters contained in the alcohol are discharged from the aldehyde discharge pipe. The dealdehyde alcohol enters the liquid phase distillation tower from the bottom of the aldehyde tower, and part of the wine head enters the mash of the post-fermentation tank or the mature mash from the head pipe.
The working principle of the distillation tower is that after the alcohol is distilled through the above two towers, the alcohol concentration needs to be further increased and the impurities need to be further removed. The purpose of the distillation tower is to remove the head-level impurities at the top, extract the fusel oil in the middle, and discharge the tail-level impurities at the bottom through heating, evaporation, condensation, and reflux, so as to obtain a finished product that meets the quality standards - alcohol.
The working principle of the distillation tower is not limited to purifying alcohol.
The function of the distillation tower is mainly to separate mixed liquids, using the principle of different liquids under different conditions, such as different temperatures and different volatilities (boiling points), to achieve purification effects.
Distillation towers are mainly divided into plate towers and membrane towers.
The plate tower is relatively common, and its structure can be divided into three parts: plate, reboiler, and condenser.
The top temperature of the distillation tower should generally be controlled at 79°C, the bottom temperature should be controlled at 105-107°C, and the temperature in the tower should be between 88-92°C when the wine is taken normally.
The water temperature of the condenser on the distillation tower should be 60-65℃, the condenser should be 35-40℃, and the temperature of the latter condenser should not be lower than 25℃.