Introduce the cable wiring method for heat exchangers.
1. Peel the copper core of the cable on the heat exchanger about 30-35mm long, wipe the copper wire clean with an abrasive cloth, and shine properly.Likewise, peel off the copper wire of the external three-core cable by 30-35mm and wipe it clean with an abrasive cloth.
2. Insert the three-core cable into the copper wire part peeled off from the external cable.Then tie it tightly with a fine copper wire.Cut off the rest and flatten with scissors to avoid stabbing.
3. Solder the three wire ends separately with solder, requiring the surface of the welding head to be smooth and free of burrs and fake welding.If not firmly welded or not smooth, it should be re-welded.Until the requirements are met.
4. When wrapping with polyester non-conductive tape, hold down half of the initial ring.Bandage 8-12 layers, after wrapping.Then cover two layers with plastic tape for strength.
5. Wrap the three wires together with plastic tape, wrap two layers, one layer is larger than the end of each conductive non-conductive layer 50mm or more.
6. After wrapping, take a basin of cold water and soak the wrapped thread in water. After 12 hours, use a 500V megohmmeter to measure that the non-conductivity cannot be less than 50 megohms, otherwise the wrapping should be rewrapped until the requirements are met.
7. The ground wire of the heat exchanger must also be wrapped according to the wiring process of the submersible cable.
Reproduced Please indicate the source:
http://www.wxmwhg.com